False Signal
3 posters
Detecting West Australian Gold :: Minelab, Other Detectors & Coils :: Coils - Minelab, Coiltek, Nuggetfinder, General
Page 1 of 1
False Signal
Can any one out there give me some advice I have been using a 4500 with mono coils and I keep getting a faint false signal when Im detecting. I have changed coils and adjusted settings but it doesn't seem to be making much difference.
Thanks
Thanks
forky
Re: False Signal
Forky,
We need more information;
Is it when you bump something?
Is it at centre of your swing or when you are far left or right?
Are you sure you don't have any metal in your boots.
Are you bumping the coil connection into the front of the box?
Probably more but that's a start.
We need more information;
Is it when you bump something?
Is it at centre of your swing or when you are far left or right?
Are you sure you don't have any metal in your boots.
Are you bumping the coil connection into the front of the box?
Probably more but that's a start.
_________________
Good luck & safe travels
Peter
[You must be registered and logged in to see this image.]
"Aging seems to be the only available way to live a long life."
Nightjar
Re: False Signal
if your not tuned properly it does that try tuning the coil over the target it should tune out if its gold cant tune out cheers john
cueite
Similar topics
» false signals in the wet
» would you dig on this signal?
» Soft signal vid - Zed - JP
» Was that signal a bit of wire or nail ya just walked away from ??
» Boosters, amps, signal enhancers etc
» would you dig on this signal?
» Soft signal vid - Zed - JP
» Was that signal a bit of wire or nail ya just walked away from ??
» Boosters, amps, signal enhancers etc
Detecting West Australian Gold :: Minelab, Other Detectors & Coils :: Coils - Minelab, Coiltek, Nuggetfinder, General
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|